Re: Fan installation
This may be a stupid question (sorry if it is!), but would it be a bad idea to print and mk5 and fan mount with PLA? I get superior quality from PLA and have had only issues making, well, ANYTHING...
View ArticleRe: Fan installation
PLA will melt/soften at lower temps than ABS so having it near a hot extruder can sometimes not work... with that said I have seen some people do this and it works... I guess it depends on ambient...
View ArticleRe: Fan installation
That's what I thought...I might pick up some of the High Temp PLA by Proto-Pasta. Has anyone tried that filament yet? Thoughts?
View ArticleRe: Fan installation
coleke wrote:RGargus wrote:I doubt that any thing else is using SIO protocol, so the A0 could be released from CE funtion on the SD memory, and CE could be hardwired. This would free up a fan control...
View ArticleRe: Fan installation
I'm struggling to get this to work on Sanguinololu 1.3a board. Have tested the pins on the board with an oscilloscope and nothings changes when I change the manual control - the fan is just always on.
View ArticleRe: Fan installation
I'm struggling to get this to work on Sanguinololu 1.3a board. Have tested the pins on the board with an oscilloscope and nothings changes when I change the manual control - the fan is just always on.
View ArticleRe: Fan installation
Hi firmware gurus,I'm not having much like dealing with arduino.I have a Solidoodle 3 with this board: http://www.soliforum.com/post/28760/#p28760I had a friend solder up the mosfet and headers into...
View ArticleClik here to view.
Re: Fan installation
I'm guessing connecting like this should work for me? Aside from the code changes of course.I also designed an extruder fan holder for a 40mm fan since I didn't really like the ones out there.
View ArticleRe: Fan installation
What psi do these fans attached usually put out? I'm looking to attach one but may use my air compressor and create my own nozzle and attachment with an air hose hooked in. I'll have a regulator on the...
View ArticleClik here to view.
Re: Fan installation
eflyguy wrote:No PSI, they simply move air so that the parts can cool..Objection - very small PSI. Air velocity right on the plastic will align pretty well with the rate of cooling. So whether you move...
View ArticleClik here to view.
Re: Fan installation
Well I almost got it together today. I just need to figure out a way to print an attachment. I'm running an extra line from my shops main air compressor into our 3d printing office. When entering the...
View ArticleRe: Fan installation
I want to put molex connectors on the fans I bought and installed. For now I'm using butt splices I crimped. Where can I get the 2 pin molex connectors used on the SD3 and SD4? They're pretty standard,...
View ArticleRe: Fan installation
jagowilson wrote:I want to put molex connectors on the fans I bought and installed. For now I'm using butt splices I crimped. Where can I get the 2 pin molex connectors used on the SD3 and SD4? They're...
View Article
